Post Title

Purpose: to measure the surface temperature distribution after CO2-laser heating of titanium dental implants using different power settings, application intervals and irradiation times. Materials and methods: 10 tissue-level-type titanium implants (Camlog Screw-line Promote Plus 4.3mm x 11mm) were embedded (Epofix, Struers ApS, Copenhagen, Denmark) and irradiated with a carbon-dioxide-laser (Denta II, Lutronic Corporation, Fremont, USA) with a wavelength of 10.6µm and at power levels of 4watts (group 1), 6watts (group 2), 8watts (group 3) and 10watts (group 4). A continuous beam mode (setting I) and non-continuous beam modes with 5second (setting II) and 10second (setting III) pause intervals were used. For each setting, a total irradiation time of 50seconds was used and repeated 10 times. The temperature was measured using external thermocouples (Testo SE & Co. KGaA, Lenzkirch, Germany) in contact with the implant surface at implant shoulder, middle and apex. A linear regression model was used to analyse the data (p = 0.05). Results:  Setting I demonstrated the most rapid increase in implant surface temperature in all three test sites as well as the greatest total temperature at 50 seconds of irradiation time. The greater the pause interval (settings II and III) during the 50 seconds of irradiation, the lower the rate of temperature increase as well as the total temperature in all three test sites and with all power levels. The average temperature difference between the apex and shoulder site was significant for test setting III for all groups, but not for any groups in settings I and II. Conclusion: Heating the internal aspect of a dental implant with a CO2-laser produces different temperature distribution profiles depending on the laser power level and the application interval. Laser-beam irradiation leads to a temperature gradient which is greatest at the implant apex and smallest at the implant shoulder.